[响度计量峰值限制器插件]Wave Arts FinalPlug 7 v7.0.1 [WiN]（7Mb）

Wave Arts FinalPlug 7 v7.0.1-R2R| 15 Nov 2023 | 6.5MB

FinalPlug结合了超前峰值限制器和ITU BS.1770响度计测量。FinalPlug可以作为插入效果使用，用于增益分段或音量最大化，也可以放置在母带处理链的最后，以确保音频符合响度和真峰值交付要求。

FinalPlug的界面非常简单。当用作响度最大化器时，选择所需的输出上限水平，比如-0.1 dB，然后调整阈值水平。随着阈值的降低，音量会增加。

要满足响度和真峰值交付标准，请选择“分析”预设，然后选择交付目标规范。这将设置集成响度和真峰值的目标水平。然后播放您的会话。随着音乐播放，集成响度和真峰值水平将显示出来，如果超过了目标水平，将以橙色显示。播放结束后，点击“匹配”。这将根据目标规范设置限制器参数。再次播放会话，将得到所需的集成响度水平，而不会超过真峰值水平。现在您可以导出符合要求的音频。

* 不需要安装iLok驱动程序即可运行。
* 我们的版本加载更快，占用的内存更少。

Peak limiting and loudness compliance
FinalPlug combines a lookahead peak limiter with ITU BS.1770 loudness metering. FinalPlug can be used as an insert effect, providing limiting for gain staging or volume maximization, or can be placed at the end of your mastering chain to guarantee your audio meets loudness and true peak delivery requirements.

The FinalPlug interface could hardly be simpler. When used as a loudness maximizer, select a desired output ceiling level, say -0.1 dB, and then adjust the threshold level. As you decrease the threshold you increase the volume.

To meet loudness and true peak delivery standards, select the “Analyze” preset and then select a delivery target specification. This sets up the integrated loudness and true peak target levels. Then play your session. The integrated loudness and true peak levels are displayed as the music plays, and will be colored orange if they exceed the target levels. At the end of playback, click MATCH. This sets the limiter parameters to meet the target specification. Playing the session again will yield the desired integrated loudness level without exceeding the true peak level. You can now export your compliant audio.
* No iLok Driver installation is required to run.
* Our release loads faster and uses less memory than legit version.